Superdrive for mac pro 2008

Helpful answers
Contents:
  1. MacPro Lower SuperDrive won't open
  2. Mac Pro - Guide to optical bay hard drive installation
  3. Similar Questions

Thankfully, there are a number of work-arounds. One is to permanently install an eject icon in the toolbar menu situated at the top of your desktop. To do this, open up a Finder window and click "Macintosh HD. If you ever want to remove it, just hold the command key on your keyboard and drag the icon off of the menu bar.

Another way to open the drive in a pinch: Open iTunes, click on "Controls," and select "Eject Disc.


  • le migliori app per mac 2013?
  • games on mac with ps4 controller.
  • Apple Footer.

Or, if you are restarting your computer, holding down the mouse button during boot-up should do the trick. You'll need to unscrew the 2 screws and slide the plate down out of the tab. When removing or installing a card, handle it only by the edges. Do not touch its connectors or any of the components on the card. Lift the card straight out from the connector to remove it, and insert it straight into the connector to install it. Using a long-handled, magnetized 1 Phillips screwdriver, remove the screw at the top rear of the front fan assembly that mounts the assembly to the logic board.

The heatsink cover is held in place by a number of tabs and magnets on the underside of the cover. You must release the tabs before you can remove the cover from the enclosure.

MacPro Lower SuperDrive won't open

Place the fingers of one hand under the lip of the heatsink cover nearest the logic board. Lift the lip slightly toward the media shelf to release the tabs and magnets under the top face of the cover. Remove the screws holding the fan enclosure in place. Mine had one at the top which screwed directly into the logic board, and another at the bottom underneath the left yellow arrow on image 1.

Place one hand on each end of the fan, lift straight up, and remove the fan from the enclosure. Replacement Note: Before re-installing the front fan assembly in the enclosure, make sure that the fan cables are routed correctly in the fan channel. This can also be slightly tricky so pay attention to the alignment of the connectors on the fan unit and logic board. Make sure the latch on the back panel is up, so that the drives and carriers are unlocked. Disconnect the power and ribbon cables from the optical drive s and remove the carrier.

Now that you have fully exposed the logic board, look for the 2 SATA ports, circled here. Start routing the SATA cable that you have already attached to the logic board up through the corner of the optical bay, following the existing wires. Make sure you have the cable all the way tucked in behind the connector before proceeding.


  • No Answers have been submitted!
  • How to Eject Discs from Mac Pro Towers: Digital Clinic!
  • Can this usb superdrive be used by an early 2008 mac pro?.
  • Mac Pro Internal SATA Bluray Drive Replacement (Early 2008).
  • Hint Options.

See the first graphic as an example. There are 4 screws provided by Apple already on the back side of the drive carrier. Remove and use them to fasten the drive to the carrier. When buying a optical drive, ensure that it is Mac Compatible. This will confirm that the drive door is removable. Connect the power converter cable to the already provided secondary power connector.

Sadly, my SuperDriver eventually stopped reading disks altogether so I replaced it.

Mac Pro - Guide to optical bay hard drive installation

But this hint definately made the drive usable for a few years after I first noticed the problem. The DVD cleaner discs work well with dusty drives too. I have a Macbook pro that was in same situation. I put in the DVD cleaner and it started working again. The DVD cleaner disc actually has little bristles right on the discs surface that brush the lens as it searches the disc.

But in a pinch I can see how this might work. Thank you for the idea. I actually managed to clean my 1.


  • Mac Pro Internal SATA Bluray Drive Replacement (Early ) - iFixit Repair Guide.
  • Upgrade your Mac Pro;
  • gmod error textures fix mac.

Nice to know, but I prefer to open up the drive and clean it this way. I did this I cleaned the lens using alcohol. Unfortunately it didn't helped at all. DVD's are still working but not CD's Those superdrives are really a piece of junk. Mine stopped working after one year. I did this and everything worked fine afterwards. Holy crap it worked.

Similar Questions

This trick is brilliant. Lost your password? Powered by the Parse. More Mac Sites: Macworld MacUser iPhone Central. One fix for non-functioning SuperDrive Feb 14, '12 D I think , experienced a long, slow decline in its performance, and finally it stopped working altogether. When I say 'stopped working,' I mean that it wouldn't recognize a disc: